S_ShowBadColorsIdentifies all pixels that fall outside a given color range, and flags them with the same color so they can be seen easily.In the Sapphire Adjust effects submenu.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Min:
Default:
0,
Range:
0 to 1.
Minimum color value. Pixels where any color channel is less than this value will be marked with Low Color.
-
Max:
Default:
1,
Range:
0 to 1.
Maximum color value. Pixels where any color channel is greater than this value will be marked with High Color.
-
Min Luma:
Default:
0,
Range:
0 to 1.
Minimum luminance value. Pixels where the luminance is less than this value will be marked with Low Color.
-
Max Luma:
Default:
1,
Range:
0 to 1.
Maximum luminance value. Pixels where the luminance is greater than this value will be marked with High Color.
-
Min Chroma:
Default:
0,
Range:
0 to 1.
Minimum chrominance value. Pixels where the chroma is less than this value will be marked with Low Color.
-
Max Chroma:
Default:
1,
Range:
0 to 1.
Maximum chrominance value. Pixels where the chroma is greater than this value will be marked with High Color.
-
Min Rgb:
Default rgb:
[0 0 0].
Minimum values per color channel. Pixels where any color channel is below the corresponding channel of this parameter will be marked with Low Color.
-
Max Rgb:
Default rgb:
[1 1 1].
Maximum values per color channel. Pixels where any color channel is above the corresponding channel of this parameter will be marked with High Color.
-
High Color:
Default rgb:
[1 0 0].
Color to mark high pixels with. Any pixel that is above one of the Max parameters will be set to this color.
-
Low Color:
Default rgb:
[0 0 1].
Color to mark low pixels with. Any pixel that is below one of the Min parameters will be set to this color.
-
Output Matte:
Check-box, Default:
off.
If enabled, output a matte which is set to white for bad pixels and black otherwise.
-
Invert Matte:
Check-box, Default:
off.
If enabled, the matte is inverted to show black for bad pixels and white otherwise. Has no effect unless Output Matte is also enabled.
See Also:
-
HueSatBright
Monochrome
ClampChroma
PseudoColor
DuoTone
TriTone
QuadTone
Tint
Threshold
Hotspots
Gamma
Solarize
ChannelSwitcher
Invert
Sapphire Plug-ins Introduction