S_SwishPanTransitions between two input clips by sliding one clip off the frame and the other clip on, and adding motion blur to give the appearance of a quick pan. This works best when the duration of the transition is short.In the Sapphire Transitions effects submenu. Inputs:
|
|
Parameters:
- Load Preset: Push-button.
Brings up the Preset Browser to browse all available presets for this effect.
- Save Preset: Push-button.
Brings up the Preset Save dialog to save a preset for this effect.
- Wipe Amount: Default: 0, Range: -0.5 to 1.5.
Determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 1 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.
- Direction:
Popup menu, Default: Left.
Direction that the clips move during the transition.- Left: Moves right-to-left
- Right: Moves left-to-right
- Up: Moves upward.
- Down: Moves downward.
- Right: Moves left-to-right
- Left: Moves right-to-left
- Blur Amount: Default: 2, Range: 0 or greater.
Amount of motion blur to use. If the direction is left or right, the blur is horizontal. If the direction is up or down, the blur is vertical.
- Overlap: Default: 0, Range: any.
Amount to overlap the two clips. Where the clips overlap, they will be screened together. This is useful for eliminating bad edges.
- Slow In: Default: 0.5, Range: 0 to 1.
If positive, causes the transition to start more gradually.
- Slow Out: Default: 0.5, Range: 0 to 1.
If positive, causes the transition to end more gradually.
