S_WipePixelateTransitions between two input clips by adding blocks of pixels of one clip onto another in a semi-random order. The Wipe Amount parameter should be animated to control the transition speed. Adjust the Edge Width and Chunky parameters for different pixelated patterns.In the Sapphire Transitions effects submenu.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Wipe Amount:
Default:
0,
Range:
-0.5 to 1.5.
Determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 1 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.
-
Edge Width:
Default:
1,
Range:
0.014 or greater.
The width of the transition area.
-
Angle:
Default:
0,
Range:
any.
The angle of the wipe direction in degrees. Use 0 for a wipe from left to right, 90 or -90 for a vertical wipe, 180 for a wipe from right to left.
-
Pixel Frequency:
Default:
20,
Range:
0.1 or greater.
Increase for smaller and more pixels, decrease for fewer and larger pixels.
-
Pixel Rel Width:
Default:
1,
Range:
0.01 or greater.
The relative horizontal size of the pixels. Increase for wide pixels, decrease for tall ones.
-
Chunky:
Default:
0,
Range:
0 or greater.
Increase to cause the pixels to be added with a more clustered ordering.
-
Seed:
Default:
0.23,
Range:
0 or greater.
Used to initialize the random number generator. The actual seed value is not significant, but different seeds give different results and the same value should give a repeatable result.
-
Show Wipe:
Check-box, Default:
on.
Turns on or off the screen user interface for adjusting the Wipe Amount parameter.