S_FlickerRemoveColorRemoves temporal color changes from the Source clip. Similar to FlickerRemove but the process is applied to each color channel. To use this effect, first position the corners of the rectangle over an area where the average color should remain constant. A middle or light gray area is best for this. Then select a Source frame that has the desired color within the rectangle, and hit the Set Hold Color button. When other frames are processed, their colors will be scaled so the average color within the rectangle is equal to the Hold Color.In the Sapphire Time effects submenu.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Rect Corner1:
X & Y, Default:
[-0.583 -0.441],
Range:
any.
The upper left corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Rect Corner2:
X & Y, Default:
[0.583 0.441],
Range:
any.
The lower right corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Hold Color:
Default rgb:
[0.5 0.5 0.5].
The requested average output color for the area within the rectangle.
-
Set Hold Color:
Push-button
.
Pressing this button has a side effect of setting the Hold Color parameter to the average Source color in the rectangle at the current frame. It causes the output to equal the Source at this frame. This button retains no value itself, and is turned back off immediately after being pushed.
-
Show Rect:
Check-box, Default:
on.
Turns on or off the screen user interface widget for adjusting the Rect Corner corner parameters.
See Also:
-
FlickerRemove
FlickerRemoveMatte
FlickerRmMatteColor
FlickerMatch
FlickerMatchColor
FlickerMatchMatte
FlickerMchMatteColor
Flicker
Sapphire Plug-ins Introduction