S_FlickerRemoveRemoves temporal flickering from the Source clip. For example, old footage with uneven exposure times can be smoothed out with this effect. To use this effect, first position the corners of the rectangle over an area where the average brightness should remain constant. A middle or light gray area is best for this. Then select a Source frame that has the desired brightness within the rectangle, and hit the Set Hold Level button. When other frames are processed, their brightness will be scaled so the average brightness within the rectangle is equal to the Hold Level. You can keyframe different Hold Level values over time to account for desirable brightness changes.In the Sapphire Time effects submenu.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Rect Corner1:
X & Y, Default:
[-0.583 -0.441],
Range:
any.
The upper left corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Rect Corner2:
X & Y, Default:
[0.583 0.441],
Range:
any.
The lower right corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Hold Level:
Default:
0.5,
Range:
0.01 or greater.
The requested average output brightness for the area within the rectangle.
-
Set Hold Level:
Push-button
.
Pressing this button has a side effect of setting the Hold Level parameter to the average Source brightness in the rectangle at the current frame. It causes the output to equal the Source at this frame. This button retains no value itself, and is turned back off immediately after being pushed.
-
Show Rect:
Check-box, Default:
on.
Turns on or off the screen user interface widget for adjusting the Rect Corner corner parameters.
See Also:
-
FlickerRemoveColor
FlickerRemoveMatte
FlickerRmMatteColor
FlickerMatch
FlickerMatchColor
FlickerMatchMatte
FlickerMchMatteColor
Flicker
Sapphire Plug-ins Introduction