S_FlickerMatchColorAdds color changes to the Source clip using the color changes from a second Match clip. Similar to FlickerMatch but the process is applied to each color channel. To use this effect, first position the rectangle over an area of the Match clip which has color changes you want to copy. A middle or light gray area is best for this. Then select a frame for which you want the Source color unchanged, and hit the Set Match Level button. When you process other frames, the Source colors will be scaled by the average Match color within the rectangle, relative to the Match Color.In the Sapphire Time category.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Rect Corner1:
X & Y, Default:
screen lower left.
The upper left corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Rect Corner2:
X & Y, Default:
screen lower left.
The lower right corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Set Match Color:
Push-button
.
Pressing this button sets the Match Color parameter to the average Match clip color in the rectangle at the current frame. It causes the output to equal the Source at this frame.
-
Match Color:
Default rgb:
[0.5 0.5 0.5].
The average Match color in the rectangle for which the Source input is unchanged.
See Also:
-
FlickerMatch
FlickerRemove
FlickerRemoveColor
FlickerRemoveMatte
FlickerRmMatteColor
FlickerMatchMatte
FlickerMchMatteColor
Flicker
Sapphire Plug-ins Introduction