S_FlickerMatchAdds flicker to the Source clip using the flicker from a second Match clip. For example, a clip can be brightened in synchrony with a flashing light in another clip. To use this effect, first position the rectangle over an area of the Match clip which has brightness changes you want to copy. A middle or light gray area is best for this. Then select a frame where you want the Source brightness unchanged, and hit the Set Match Level button. When other frames are processed, the Source brightness will be scaled by the average Match brightness within the rectangle, relative to the Match Level.In the Sapphire Time category.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Rect Corner1:
X & Y, Default:
screen lower left.
The upper left corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Rect Corner2:
X & Y, Default:
screen lower left.
The lower right corner of the rectangle which is used to measure the flicker, in screen coordinates.
-
Set Match Level:
Push-button
.
Pressing this button sets the Match Level parameter to the average Match clip brightness in the rectangle at the current frame. It causes the output to equal the Source at this frame.
-
Match Level:
Default:
0.5,
Range:
0.01 or greater.
The average Match brightness in the rectangle for which the Source input is unchanged.
See Also:
-
FlickerMatchColor
FlickerRemove
FlickerRemoveColor
FlickerRemoveMatte
FlickerRmMatteColor
FlickerMatchMatte
FlickerMchMatteColor
Flicker
Sapphire Plug-ins Introduction